Anyone know where to buy these grousers please?

[Rimrock]

It's the correct tracks Ap is referring to. It possible to get them for better prices than on the rcbrmin webshop, through agents in China. But the ones here at the forum who has experience with it, can speak for them self.
Tracks are 50 mm wide.

[dozerbuilder]

Originally Posted by Rimrock

It's the correct tracks Ap is referring to. It possible to get them for better prices than on the rcbrmin webshop, through agents in China. But the ones here at the forum who has experience with it, can speak for them self.
Tracks are 50 mm wide.

That's the ones alright. 50mm grouser plate width (2.00") as you say. Now to hunt them down.

Cheers.

[j_hammer]

has anyone ordered these and what are they like.

[dozerbuilder]

Originally Posted by j_hammer

has anyone ordered these and what are they like.

j-hammer, as a result of the helpful answers here to my request for information, I ordered a dozen of the single-bar grousers (which have an attached 1-piece link arrangement) here: http://www.rcbrmin.com/excavator-112...ces-p-683.html.

I only ordered a dozen to start to assess their practicality for my proposed build and also so I could roll them around over half the circumference of a sprocket or front idler to check the pitch.

So I'll be happy to report back when I get them. Said to be 9 days by air from China to AUS so assuming all goes well.

Then I'll decide if I'll use roller #80 offset roller chain joiner links and spot-welded custom stamped plates or the ones I ordered.
Cheers

[dozerbuilder]

Originally Posted by dozerbuilder

j-hammer, as a result of the helpful answers here to my request for information, I ordered a dozen of the single-bar grousers (which have an attached 1-piece link arrangement) here: http://www.rcbrmin.com/excavator-112...ces-p-683.html.

I only ordered a dozen to start to assess their practicality for my proposed build and also so I could roll them around over half the circumference of a sprocket or front idler to check the pitch.

So I'll be happy to report back when I get them. Said to be 9 days by air from China to AUS so assuming all goes well.

Then I'll decide if I'll use roller #80 offset roller chain joiner links and spot-welded custom stamped plates or the ones I ordered.
Cheers

UPDATE.
Well I got an email from despatch at rcbrmin today to say they are shipped so I'm pretty happy with the communication and prompt service..

Cheers