Liebherr 574

[gauthib12]

Hi Reg,

Are you able to let me know a bit more details on the motors you used? i.e rpm, torque, price, where did you get em? I was looking on the dx.com website..there are some good deals, but having a hard time to decide..I am assuming you have all 4 controlled by a single esc...any advice would be appreciated...thanks!

Blair

[RCP57]

Hey Blair, I bought the motors off of eBay but I have also bought them off of Amazon and from Robot Shop. These last ones from eBay look exactly like the rest but have different motors(windings I guess). I forget the numbers off the top of my head but lets just say the normal motors I use are a something, something S and the new motors are just something, something. Needless to say they do not have the same power even though they look identical. They do however seem to have an adequate amount for this particular model though, I just would have liked more.lol Anyway, what I am running are 25mm diameter, 77rpm, 6 volt motors. I can dig up a link to the ones I purchased if you like. So many sellers have the same or nearly the same stuff for sale. I bought these last ones because they were under $10 a piece and had free shipping. I won't buy them again but they are doing the job. I also have the same type in my Bruder Mack but use 133rpm ratio. Hope this rambling helps...

Reg