made a tank and smal problem?

[cosworth34677]

Originally Posted by Serviceguyuk

It may be as simple as a little over filling.

Oil does heat up in any hydraulic system and will expand as your pump works.

Try draining or syphoning a little oil out and then run it.

Just trying help

Originally Posted by thebigo

Did you vent your tank? Install a small vent tube somewhere behind your tank.

i took out a Little oil. helped alot but still dose it.
how do you keep the oil from coming out the vent?

[chris deacon]

Originally Posted by cosworth34677

i took out a Little oil. helped alot but still dose it.
how do you keep the oil from coming out the vent?

Fit a long pipe on it and keep it higher than the tank?

[Serviceguyuk]

Originally Posted by cosworth34677

i took out a Little oil. helped a lot but still dose it.
how do you keep the oil from coming out the vent?

Chris is right, just run a pipe higher than the tank top. If you are worried about leakage you can get a filter/breather end fitting but always keep that upright and higher than the tank top. Gusto make small fittings and I'm sure they make a 3 or 4mm glass/ceramic breather end fitting that will simply push into the end of your overflow pipe.

Bets of luck

Just trying to help

[Serviceguyuk]

I ran out time to edit my post but as an alternative you can use a small engine fuel tank filter like this one probably available from anywhere.


http://www.aliexpress.com/item/Small...234031721.html



Just trying to help

[Joe25]

Originally Posted by Serviceguyuk

Gusto make small fittings and I'm sure they make a 3 or 4mm glass/ceramic breather end fitting that will simply push into the end of your overflow pipe.

Could you post a link?