Dragline Crawler Build

[Rvjimd]

Tom,

Thanks. I thought I would probably need to angle the drive dogs on the pads. I have dividing plates so I can try that if it comes to that. I think I might start by just making a few more samples and make them a bit smaller each to see if it get better.

Also, I figured it would be simple to just drill the holes like I did and use brass tube to see if it looked close. Then, if I get where it looks like it should work I will make an actual tumbler and mill it to look like it should.

Jim

[Rvjimd]

Reg, yea, that does make sense, thanks

Jim