|
|
|
|
#1
09-16-2015, 05:03 PM
|
||||
|
||||
Re: Great Dane excavating co.
Thanks Mario , that's perfect-just what I was lookin for. And thanks for the rpm, I was going to rig up some kind of Popsicle stick on shaft because the tachometer I have is for airplane props. And it may not read that low!?!??
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
#2
09-16-2015, 06:14 PM
|
||||
|
||||
|
Re: Great Dane excavating co.
No problem. That is one of many voltage ranges they offer. The one I use is 5-16V. 200W.
I like my conveyor speed but if I was gonna be anal about it, I'd probably go with something in the 50-75 rpm range and use the regulator to set it where you need for different materials. I'm sure mine are too slow for a coarse material like small stone or pebble. They'd probably just roll back. It would be nice to have more speed range to work with.
|
 |
| Currently Active Users Viewing This Thread: 22 (0 members and 22 guests) | |
|
|
Hybrid Mode
