Bruder 574 conversion

[Cat966c]

Sweet! I'm actually doing a loader build as well, this should help me!! This is perfect! Thank you! Are you going to post where you get the servos and what they are cause I'm new and that would be cool. I also am new to the whole transmitter and receiver thing and also new concerning what motors to by/what's the best one for the lowest money lol

[jdwtrans]

Hi, I have done quite a lot of research on different ways to do this conversion.
I have already purchased things like Drive motors for the wheels, Esc's both brushed and brushless, ( I didnt even know what the difference was ).

I have also purchased some aluminium in different sizes. I got the tyres that i will be using and i also have the radio, which is a Flysky i6.
I

[Cat966c]

Originally Posted by jdwtrans

( I didnt even know what the difference was)

Yep, right there with ya man. I don't know where to start or what controller to buy, they all seem so expensive. I was thinking of just buying the hobby engine loader with the spectrum remote and replacing some of the motors with ones that have better range of motion (if that's doable)

[jdwtrans]

Originally Posted by Cat966c

Yep, right there with ya man. I don't know where to start or what controller to buy, they all seem so expensive. I was thinking of just buying the hobby engine loader with the spectrum remote and replacing some of the motors with ones that have better range of motion (if that's doable)

I would not advise going down the hobby engine route if you are trying to achieve that "scale" look.