Bruder Mack Half pipe dump truck

[SteinHDan]

Hi RcBruder!


I think you will be fine with running all three motors on the same speed controller. I run four on the same controller in my version.

For inspiration you could have a look at my low-cost build here:
- http://www.scale4x4rc.org/forums/showthread.php?t=80393

It's not the same Bruder truck, but I believe the rear end is exactly the same. The front end is a bit different. I wish I had used your Bruder model for the build. It looks much better, IMHO.

All the 3D-printed parts are downloadable for free, just click the links in one of the later posts.


Best regards,
Stein :-)

[RcBruder]

Love the way it turned out! The only problem is i am not sure that i can use that same idea to dump the bed as its curved and it may not mount right. Thanks though! Love the drive setup.