Skeeters contracting services

[frizzen]

On mounting the drive servos, maybe make an inboard sandwich plate that lets you clamp plastic body between aluminum sheets, and also wraps around the servo bodies (square holes they slide into) with the center mount holes tapped instead of using nuts?

Also for visable wire management, i like to clear tape over wires on the hidden side of the part.

[skeeter]

Originally Posted by frizzen

On mounting the drive servos, maybe make an inboard sandwich plate that lets you clamp plastic body between aluminum sheets, and also wraps around the servo bodies (square holes they slide into) with the center mount holes tapped instead of using nuts?

Also for visable wire management, i like to clear tape over wires on the hidden side of the part.

I would much rather had the Aluminum plate, or other structural addative(s) on the inside, but there wasn't room. The micro servo's are a=right against the floor board of the model.

Remember this?
unnamed (9) by Anthony Kalnoski, on Flickr

Well, it now looks like this!
unnamed (76) by Anthony Kalnoski, on Flickr
SOMEETIMES it pays to be a serial builder. I robbed it from that drive sprocket, & re-purposed it to the Bruder skidsteer conversion. Although it is a different thickness that the others, I was able to use shims to make them the same thickness.

Now I've got this.
unnamed (77) by Anthony Kalnoski, on Flickr

I didn't get any farther tonight. It's getting late & it's dinner time.