|
|
|||||||
| Mechanical tech This is for the mechanical parts of a model. Gear reductions, Axles, Transmissions, General drive line |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
01-29-2018, 01:00 PM
|
||||
|
||||
Re: Winch set up?
Look at the CTI Thor 15 speed controllers. They are small and easy to place.
__________________
Emil G | MFZ Blocher Fendt 926 | RC4WD Volvo EC480 excavator | Carson LR 634 | Kenworth 6x6 hauler | Kenworth 6x6 dtrk My channel: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Construction site on Facebook: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Pictures on Instagram: To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
#2
01-29-2018, 05:27 PM
|
|||
|
|||
|
Re: Winch set up?
thnx again. im tottaly new to all this. in my mind i was going to be able to wire up the small gear motors into the servo channels. and run them just as if they were servos because thats what a servo is "a small gear motor". with some type of tweeking that is.
|
|
| Tags |
| winch |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
