Fully 3D printed John Deere 1/10 scratch build

[agriRC]

I have done some research and found my 30mm fan throughput is 4.12 CFM. This is obviously not enough. Ideally I would like to treble this so will require a 50mm fan. So a re-design of the enclosure is required. Handy for for you guys to know for the anyone who wants to build there own smoke generator. I cannot confirm a 50mm will work but fairly confident. The vape coil I used was a 0.85 ohm clapton coil. There are many different types of coils out there for vape modders. Any should work.

[agriRC]

Here is the cab 'Isobus' system.







I created 32x32 pixel icons for PTO,DIFF LOCK,4WD and BEACONS. When they are enabled the image is then inversed to look illuminated. Screen measures 0.96" diagonal and is crystal clear. When it powers up it shows the john deere logo. The code below takes serial commands 1, 2, 3 or for and toggles the icons respectively. The fuel gauge will be battery level and RPM will be throttle. This code was developed for testing you will need to modify to include in your projects but you can see how it is done. I will include different screens for implements. The screens will then be changed via the remote.



I made a enclosure for it and mounted it in the cab roughly where it would be in real life and also give me a good view from the FPV camera.