Bell 50 ton Dumper - ADT

[Lil Giants]

Does it say anywhere the reduction or output rpm? Thanx for the pic.

The biggest pain with re-orders is the money/currency exchange. Atleast the last go around I was able to phone to make small payment with cc#. However, it's nice to get everything in one shot.

[elliot330]

Originally Posted by Lil Giants

Does it say anywhere the reduction or output rpm? Thanx for the pic.

The biggest pain with re-orders is the money/currency exchange. Atleast the last go around I was able to phone to make small payment with cc#. However, it's nice to get everything in one shot.

Hi Joe,

They are marked up as 100:1, but not RPM details. I temporarily connected one up to a 7.4volt battery and its pretty slow. Are you still looking for one for your dumper? If so, then I will do some more research.

Elliot

[elliot330]

Another busy night…

Rear suspension bolted up and ready to accept the axles… the holes in the chassis are a little tight, I think this is due to them being laser cut rather than drilled, but easily overcome, just run a 10mm or 6mm drill bit through it or whatever size the hole is meant to be. Job done…

Onto some pictures



Bolted the articulated swivel joint on, again another oversized very well engineered part, the fit of the pieces is so good. I know anyone with an ounce of machining knowledge could do it, but I’m still amazed at the tight tolerances!







The axles still needed wiring, but thought what the heck, lets bolt them on…

[elliot330]

Then I thought, lets bolt the front on and see how big this thing really is…




So, I got that far, lets put the wheels on!








That’s it for tonight…!