|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#2
03-22-2011, 03:48 PM
|
||||
|
||||
Re: Mack M75SX
This truck is really looking really good. I understand you are running twin motors with different-from-stock pinions and driven gear going into the transmission? Would appreciate some detail on what gears you are running and did you have to build the two-motor bracket.
Thanks! Ken
__________________
Big iron is awesome! 
|
|
#3
03-22-2011, 04:05 PM
|
||||
|
||||
|
Re: Mack M75SX
Ken It's an E-max tranny they come with 2 motor set up . The best guy to tell you about what I have would be Travis . I'm kinda trusting his jugement on the motor trans setup . If it works and has what I need for the pan , I'll be putting these in them too . I like the 2 speed idea .
 thanks Troy  Rob the set up will take longer to true it up then to cut . If I get the CNC mill working , it'll be easier on that then the lathe , I'm thinking . If not then in the 4 jaw . Steve
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by ihbuilder; 03-22-2011 at 04:07 PM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
