1/25 6 Axle Lattice Crane

[Southgate]

I just got back from a longer look at that BaneBots site. It's like being whopped up side the head with a board. I'da had this crane done by now and on to the next adventure if I'd known they existed. The prices are unbelievable, especially for US made. The motors they have, the electronics and such...

It makes me want to finish this one up and build another! I had no desire to build another after this one. I thought it was too much. Well, I'm not complaining here, just be aware that I've just had a major eye opening, and it's kinda hard to take, as welcome as it is. Oh, I still like my crane, it has kept the gray matter busy for about 4 years, teaching me good new stuff all along the way, and forcing me to meet challenges I never expected. I do intend to do the upgrades I mentioned above. Those other parts that get taken out and replaced will go into the box of stuff for later use. No waste here!

Then I went and looked at what some of you guys are building in construction equipment. Makes me dizzy for sheer amazement!

I hope I will have some useful info to share with you guys, and not just sit here and soak it off ya.

The question still stands, Steve: Do you know if those Banebot controllers operate these iddybiddy current motors smoothly at SUPER slow speed? That is pivotal.

And, um...How'd I get 5 stars? I've only been here a couple days, trying just to stay in my seat. Just curious. Dan

[ihbuilder]

Dan those esc's should work , I have the larger 1 in my paystar with a 75t lathe motor no problems and smooth you also could look at http://www.robotmarketplace.com/prod...ntrollers.html . this place compiles a bunch of manufactures together . now read specs carefully some are 1 direction . I had the same prob as you when I started and thanks to these guys and a lot of i net research from a long gone forum . As for 5 stars you earned it

IHSteve

P.S your fitting right in with this league