|
|
|||||||
| Get it out of your system! HERE! You have a gripe,bone to pick, Tamiya vs Wedico or just have to let it out! THIS IS THE ONLY PLACE TO DO IT! |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
07-02-2011, 10:00 AM
|
|||
|
|||
Re: Alright
Hey Steve not sure how thick your floor is but we set up a friend of mines shop and he has infloor heat.we put in a Cnc,huge metal break and a lath all on 2x6 oak planks with rubber mats underneath with no problem to the heat coils
The place he bought them from had the same infloor heat and they were told that the weight distribution would not be a issue if he set it up this way It has been about 3 years now and everything seem to be fine Not sure how thick your flood is but his is 3 to 4 inches 
|
|
#2
07-02-2011, 12:39 PM
|
||||
|
||||
|
Re: Alright
Spudd , I got 4" @ 4500PSI mix the lathe no problem but the mills are 6500Lbs and 8500 Lbs not only that I'm running out of room and available elc
 I had always planned to expand the barn and bring in a 480v service .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
