|
|
|||||||
| Highway Trucks and Trailers On road trucks and trailers single and twin axle trucks. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
08-10-2011, 07:40 AM
|
||||
|
||||
Re: Old School Peterbilt - First Build - lots of photos
Thank you - I think. The selection is mind boggling. Any hint on which I should be looking at? I was thinking this one:
Drill Quantity - Individual Drills Metric Drill Size - 2.5 mm (.0984") Drill Bit Style - Short–Length Drill Bits Drilling Depth - 9 mm Short-Length Drill Bits - General Purpose Drill Bit Composition - High-Speed Steel Surface Treatment - Black-Oxide Flute Type - Standard Point Angle - 135° Point Style - Split Overall Length - 43 mm Flute Length - 14 mm Shank Type - Straight Specifications Met - Not Rated Note - The shank diameter is the same or slightly smaller than the drill bit size. Short length for less breakage - other than that pretty standard. Look OK? When it comes to the taps I am totally lost. Advice? Thanks!
__________________
Michael also known as "The Crimson Corsair" To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by CrimsonCorsair; 08-10-2011 at 07:42 AM. Reason: Easier to read 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
