|
|
|
|
#1
10-15-2011, 02:46 PM
|
||||
|
||||
Re: low budget loader,I hope!
Nice work, as usual, Fred! So are you running everything on 7.2 volts, or 14.4 volts? Packs in series, parallel, or one for the drivetrain, and one for the pump?
The bucket reach looks good. One thing I was going to ask - are the pivots points and joints on these models bushed at all, or does it not matter? Aluminum will eventually wear out, I would guess. Just curious if anyone worries about that sort of thing. I never really saw any Stahl or Wedico machines up close. Do they run bushings? Those are some nice battery packs. 2/3A cells, right? Did you build them yourself, in that configuration? I can think of a couple uses for a pack that size. Where did you find them?
__________________
Nathan Last edited by Espeefan; 10-15-2011 at 02:49 PM. |
|
#2
10-16-2011, 02:11 AM
|
||||
|
||||
|
Re: low budget loader,I hope!
Quote:
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe |
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
