5 ton brass/copper build

[crawler07]

thanks for all the encouraging words! you correct Freddy I have no need for additional weight on this thing but I do think Im going to be in need of some beadlocks..

Managed a little time this morning.
Started on the inner fender(driver side) .I had been over thinking this entire process,I couldnt wrap my head around how to make the louvers so I just went into the basement and started looking through my punches and chisles but none of them looked like what I needed then I came across a wood chisle and it looked perfect. I triyed to make it from all brass but it was to hard to get a smooth cut. So I cut the louvers into copper and then installed it into the brass











I hope to build the pass side and the steering shaft tomorrow morning..