![]() |
|
Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
that loader is going to be a horse lol nice work one of these days i will get the two others i have working and then i will start on a couple new ones lol
__________________
I built this thing and have it working now what do I do with it? |
#2
|
||||
|
||||
![]() Quote:
![]()
__________________
You are an inspiration to many To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. , you will not be forgotten. R.I.P. FGD Work Hard, Play Hard! Never Forget- 343 |
#3
|
||||
|
||||
![]() Quote:
![]()
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#4
|
|||
|
|||
![]()
Wow, that's a nice looking loader. You sure have some talent at building. Did you ever get your hydaulic pump going or are you building another one? Will you buy or make cylinders? I think you said on your Mack, another great project, that your cylinders did not work out. Did you ever think about just buying a longer air cylinder, cut it to length and then make new ends. That way you get a finished bore and rod assembly that you know will work. You would only need seals and bushing for the rod end.
Richard |
#5
|
||||
|
||||
![]()
Rich , I had trouble on the tele cylinders for the mack only do to not enough time on them
![]() ![]() ![]() ![]()
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
#6
|
||||
|
||||
![]()
do these look beefy enough ?
![]() ![]() I've been working on these here and there . get a free min or to when the mill not busy ![]()
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|