|
|
|||||||
| Euro Style Trucks and Trailers A place for the Euro style trucks single and twin axle trucks and trailers... |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
12-04-2012, 09:20 AM
|
||||
|
||||
Re: Magirus 6x6 German tipper from the 1950s
Hello all,
8mm threaded rod for the scrwe drive, lathed one side to 4 and the other to 5mm. To avoid damage of the screw, i used two hex nuts in the lathe.   In this picture, there is only a 5mm screw drive, but its able to lift a 6 kg hammer laying in the front of the dumping body-  One side of the dumping body:  Best Regards Wolfgang
__________________
Best Regards Wolfgang To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. Last edited by Seilbagger; 12-04-2012 at 09:26 AM. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
