twins

[D8R]

Another fine digger coming up, Like that weight with the logo in it.
How many times do you have to change setting or can you make it all at once?
Dan

[ihbuilder]

Az , Nate thank you

Dan, thank you , 1 setup as of now all done by 3D milling . I'm going to have to set it on the 2* taper from top to bottom to clean up the logo . A sin plate would be nice right now But , I'll make do . The bottom part I'll do a couple setups cause it's only 1" thick . I was going to flat surface all the angles with jigs . The 3D work actually ran pretty quick at 120 IPM with .5" ball mill . finish came out good for paint . The logo area took the longest , that I learned would be better on another setup

[ihbuilder]

I let it finish up last night with the lights out then finished it in an hr this morning. this is 4/5th of it so far .

[RCP57]

sweet!