Volvo EC300D

[Hemi1966]

Nice work Reg, it's easy when you know what you are doing
What's the material thickness?
Was that upper inside weld hard to do?
Can you take a picture of your torch. I'm thinking of purchasing a smaller air cooled torch, the one that came with the machine is water cooled and quite large.

[RCP57]

I wouldn't really say that I know what I'm doing. This material is .100 thick so it is much easier to weld than the .063 I normally work with. The weld inside was a tricky one to do once both sides were in place. I use 150amp air cooled torch and for this I also used the short back cap which makes it much easier to fit into tight spaces. I will take a picture of it tomorrow when I make the other bucket.

Reg

[chaseracer]

looks great