|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
10-21-2010, 01:18 PM
|
||||
|
||||
Re: D9R and 463 pull scraper
Joe, I think what Ken wants to know is- if you use an O ring for a .5" diameter cylinder, what diameter groove do you put in the piston? Do you just measure the O ring thickness and make the groove that dimension smaller than the cylinder? Or is there some sort of chart or rule of thumb that you go by when making the piston grooves?
Lynn 
|
|
| Currently Active Users Viewing This Thread: 3 (0 members and 3 guests) | |
|
|
Hybrid Mode
