|
|
|
|
#1
11-05-2013, 11:33 PM
|
||||
|
||||
Re: Hauling Dirt out of my basement (present day)
Brrrr it's cold outside, a high of -3
 and I've already have my 'change of seasons cold'  good reason to stay inside & get busy with the hobby again.  Last week I fixed my JD850, DESTROYED the cog belt, worn smooth & the motor pulley too, the bottom pulley has some serious wear as well. Good to have spare parts on hand, it's running order again & back in the quarry. Used the 850 a few hrs over the wkend, 1st time since mid Aug, gotta be a new record for me - no rc for 2,5 months!     The loader needed a little attn., the bolts that hold the cyl mount fell out, relatively quick simple repair... just the kind that I like!  And here's one of about of six conveyers nearly completed, I got this far just before harvest. I have the rollers turned for two more much longer conveyers. This one is just over 12inches, it'll be the pit conveyer. I sourced the belt from a front garden tractor tube, width of cut is 65mm. 
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#3
11-06-2013, 11:38 AM
|
|||
|
|||
|
Re: Hauling Dirt out of my basement (present day)
Joe you can definitely find all the weak spot even if it takes a while. What is the shop situation is it finished yet? Cold, it was 22 degrees here the other day but almost 60 today and then going down again good phenomena weather snow not far away. Ed
|
 |
| Currently Active Users Viewing This Thread: 28 (0 members and 28 guests) | |
|
|
Hybrid Mode
