|
|
|
|
#1
12-08-2013, 04:13 PM
|
||||
|
||||
Re: Hauling Dirt out of my basement (present day)
Kordell, here's Joe's build thread of the D9 with lots of pics.
 http://www.rctruckandconstruction.co...tpusher9+dozer I wish I would have had this big daddy 850 when I started the basement excavation Greg, would have been a lot more fun than swinging a pic axe for the 1st 20cu yd.  I got my RCP57 gravel boxes on Friday, one for the green GL & the other is for the pup trl it will pull. These boxes are as described, direct bolt on to existing stock Tamiya holes in the frame, solder the motor wires & run them up to an esc & you're good to go!      You got the length I requested Reg dead on, I didn't need to slide it back at all.    Now to get busy with the pup... not a lot to do, but making my own beefy pintle loop & hook will take some time. 
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
12-08-2013, 06:13 PM
|
||||
|
||||
|
Re: Hauling Dirt out of my basement (present day)
Very nice setup!
__________________
Jarrett
|
|
#3
12-08-2013, 07:11 PM
|
||||
|
||||
|
Re: Hauling Dirt out of my basement (present day)
You went silent for a couple days Joe and I was getting worried! I didn't know if you were Happy, Happy or cursing me!lol I Am glad the GL box fit the way you wanted! I like the way you reshaped the rear plate too. I took your suggestion and widened out the bottom of the V on the last couple I made too.
Now I can rest a little easier tonight!lol
|
 |
| Currently Active Users Viewing This Thread: 6 (0 members and 6 guests) | |
|
|
Hybrid Mode
