First build ,cat D11

[Cooper]

I'm not a machinist , just learning. But for you that are I didn't want to spend $ for a insert grooving tool (and don't like to wait for mail )that I don't think I will use much. I did a little research and tried to grind one out. It's a hss blank and I have the end just a touch wider. Will it be ok to use it with the top staying flat? Many set it a touch below center? Planning on using it on some 1/2" stuff. Only a groove deep enough for retaining clips.

And got the motor mounted, will be counter sinking bolts or using button head.

[ihbuilder]

You should be fine if you have a small relief on the bottom too . I've cut 100's of grooves with home ground grooving tools . If you need any help come down to the shop anytime , I'm about an hr south of Williamsport .

[Cooper]

Originally Posted by ihbuilder

You should be fine if you have a small relief on the bottom too . I've cut 100's of grooves with home ground grooving tools . If you need any help come down to the shop anytime , I'm about an hr south of Williamsport .

Thank you for the invite, might have to look you up, or keep me in mind to notify of any shows, clubs, pertaining to rc trucks, equipment in our area. Closest rc to me is hidden hanger, takes me about 45min. I live about 10min south of Williamsport.