GMC PD4501

[Daveroo]

im not sure if this is the place to ask,,or should it be in the builders section?

but here i go..ive decided on two long term builds..a set of double bottom dumps,pulled by a single axle tractor.

and two is a GMC PD 4501 (Greyhound Scenicruiser)..here my question,on the PD 4501,would it be better to build a skeleton type frame work? ,or carve a master "plug" from some sort of soft (workable?)wood? and maybe fiberglass the mold?..or use it to form brass or copper sheet?..

but if i did the plug,and fiberglass..i guess id have to make a mold on the plug,then turn it over and fiberglass the inside to make the detail ect correct?...

gosh i dont know what would be harder..

[rcguyfarms]

Is this close to what ur are planning to build? Pics are from when I made them

[Daveroo]

yes sir..thats them...i always enjoyed watching them on jobsites

[rcguyfarms]

Pm sent