Scaleart - assembling an Arocs 8x8 roll on roll off kipper

[Rakthi]

Finishing of the cabine - Part 1

Started with the seats

Left the passenger seat and right the driver's seat. Neatly packaged and best not opened together and parts mixed as there is a definite left and right seat.



Started with passenger seat





These parts supposed to be glued together with super glue, but after I test fitted them they were solid as can be. So left them as they were. If I ever find the right material I can then make a miniature safety belt like the guys in Germany do.



Screws on to base



Seat cushion next



Bolts on from below with the same self tapping screws (one you do not see because I used one of my black ones.



Passenger seat right side



Left side



Both finished



Next steering wheel and steering column

The covers get glued on with super glue.



Make sure the square nut is well seated. In this picture it is not right. sits too high and then the cover doesn't fit.



Sticker of instruments stuck to the provided piece of plastic



The steering column attached to the driver's side dash with 2 M2x10



Top of the dashboard and passenger's side. The little part is painted in silver by me. Only part I put some paint on. Don't trust myself to paint the little buttons etc.

[Rakthi]

Part 2

Other side



Prepping to put the parts together



Here missed some pics - got distracted by the cats who caught some critter and let it loose in the house.

Missing step is screwing the lower part of the dashboard on.





Prep the whole console for installation in the cabin. Gets attached with 2 M3x6. Lazy and just took the ones that were used for painting.



Installed. The left one had to be removed otherwise can not get the console in place. Getting that one screw in is about the most difficult part of this whole job.



Now the seats go in. Also install screws before inserting in cab. Slots are provided for that in the base





Next is the mirrors and other miscellaneous bits. I didn't take pictures here because it all gets glued together with super glue. Don't like working with it as it sets fast and you can't afford mistakes.

Not a difficult job really. Here is picture of the page in the manual



Part of the mirrors were labeled wrong. The bigger part of the main mirror needs swapping L en R. Pic is of the left mirror. The mirrors can be adjusted.







That's the driver's cabin done with. Now back to the more interesting bits which is finishing the hydraulics. Probably start on that later in the week.