Bruder Conveyor Brass Rebuild

[Rvjimd]

Here is a video link to your build. Do you think the 195 rpm is going to be about right? Were you able to measure the speed of the belt or just a guess? I ordered several motors last night in that range from a bit slower to faster. Thanks for the video!

For tracking i crown the rollers a bit, it doesn't take much, but with the center spline and original rollers you may not need to deal with it.

https://youtu.be/8DsMjBCIgkw

Jim

[Highover]

According to my math it should cycle a belt length every 4 or 6 seconds... but i can adjust that with the voltage. But it was mainly a guess... so heres hoping.

[Rvjimd]

Ya, I'm hoping I get something close with the new motors I ordered last night.

I am going to run a pulley or possibly chain and sprockets so I have a bit of adjusting I can do with the final ratio there to get the belt speed where it works good.

Jim