|
|
|
|
#1
09-30-2018, 01:29 AM
|
||||
|
||||
Re: LilGiantsConstrCo
Getting ready for the winter dig season
  Swing motor had a bit of wobble in its mount plate  Added some blue locktite to the bolts & let dry before installing bolts  Not sure if I got a leak or if I'm just pushing the oil too hard making it weep every so little from somewhere... couple yrs ago I changed Jung pump from model# 4002 to 4003 increasing flow 30% to 1.8L/min, a definite improvement to move boom - stick - bucket simultaneously with good speed & no cavitation. Not touching pressure from where it was set with older pump, the pressure did go up to nearly 40Bar... Lots of Q-tips & toilet paper, I got it pretty clean again. Can't see any notable leaks & have never had any significant volume drops in short periods of time the last yr.       Put it back together & it's off to the tunnel to finish digging out the walkway area... year #8 for the Beast  If I were to guess the hrs, something close to 1600
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
09-30-2018, 10:16 AM
|
||||
|
||||
|
Re: LilGiantsConstrCo
Joe, I always enjoy seeing the posts about breakdowns and maintenance just as much as everything else!
Question: you are using postimage to host and display photos? Seems to work okay from my perspective, any special setup fees or other info about the service? Not sure I have heard about this one yet, is it fairly new? Carry on... Jim
|
 |
| Currently Active Users Viewing This Thread: 118 (0 members and 118 guests) | |
|
|
Hybrid Mode
