NorthEast Logging Co.

[Trucking4u]

Well, another weekend of unproductivity! I did get a little work done on the truck though. I fabricated some basic suspension parts for the rear axles. And finished up the differentials, driveshafts, and motor

[img] [/img]

But other than that, I have not done much. Even those solid beam suspension parts are messed up. I made them to short!!!


Still more to come!


Jon in Vt.
The Northern Rednecker

[Trucking4u]

So, still in a slump.

But I have gotten a little bit of work done in the past week or so.

This is a solid beam non-steering lift axle.

[img] [/img]


It was a long project to get this to print right, then to figure out a mounting system for it, then to realize that I was not going to use it on the T800W frame, it is too short!

Still, I am slowly making some progress on the T800W build. Although, I have recently come across the idea of using all Tamiya parts on my differentials, so it is done right, as the plastic gears are prone to binding up.

[img] [/img]

Feel free to leave a comment!

Jon in Vt.
The Northern Rednecker

[Trucking4u]

Soooooo.....
It's been almost a month since my last post. I have been busy with some family stuff, and work, and occasionally doing a little work on my T800W.

[img] image uploading [/img]

I bought some tires for my truck. Including some RC4WD Super Wide 1.7s for the front side.

Other than that, not much going on! I also started a half round dump trailer build, but I think the chassis might get a custom wood chip style box, I need to move a large amount of rubble out of the log yard, and I won't have the dump set up complete until sometime this winter.

Thanks for reading!

Jon in Vt.
The Northern Rednecker

[Trucking4u]

So....
Not much going on around here....
I kinda broke my arm while I was riding a four wheeler a few weeks ago... unfortunately I can’t use my arm for at least another week, so that halted work on the T800W.


Jon in Vt.
The Northern Rednecker

[skeeter]

The non steerable drop look good sitting there by the truck.

BUmmer to hear about your arm. Here's wishing you a speedy recovery!

[Trucking4u]

Back in the saddle! (Kinda)

My arm is still in a cast, but I managed to start a new suspension on my T800W. It’s kind of like a 4-bag air ride suspension... without airbags.

[img] [/img]

[img]

[Lil Giants]

Pretty cool to watch you try to 3D print a trk, keep going with it, very interesting

I feel your pain in the arm, I took a tumble on my quad spring of '07 & crack my pelvis, no cast & no hobby activity for 3 months! Take 'er easy

[Trucking4u]

Hello all....

Thank you Lil Giants, yes it has been taking it easy for the past month and a half, only 4 days left in a cast for me. WooWoo

Anyway, not a whole lot going on around here.

Jon in VT.
The Northern Rednecker

[Trucking4u]

So it’s been a hot minute since I’ve shown any work on my truck.... and I still don’t have a lot to show for my efforts. The chassis is finished for the most part. I just have to fix the front hub for the wide steer tires. After I finally test drive it, I will finish the cab and hood.

[img] [/img]