2 IH 433 payscrapers (ps433-2 moves)

[td9clyde]

Steve ........hows things going? haven't seen any update pics lately hows your 40 comming along?

[ihbuilder]

Originally Posted by rc_farmer

Steve, you are doing a great job, can't wait to see you cut some mud!

yea I can't either

Originally Posted by td9clyde

Steve ........hows things going? haven't seen any update pics lately hows your 40 comming along?

back on the shelf for now Henry , same with the 40 . I kinda got this new toy and got to get it making some dough and right now It's got me a little trying to figure why it will not come off em stop error 04 it seems 2 servo amps where replaced within months of each other but 1 does not appear to have been replaced . Also trying to figure out how a running machine before I bought it ( saw a vid of it running maybe this 1 or the 1 they still use ) and not when I set it up 1 referb amp $1000.00 for glentek and $350.00 for a rebuilt SD1525-16 which I think is OEM not only that , I got orders and trying to get some of these trls wrapped up and out of the shop till I decide to light them up .

Steve

[ihbuilder]

well lucky for me there's nothing wrong with the mill now I just need phase conversion for the spindle turns out I forgot a wire when separating the control from the power switch for the whole machine .

IHSteve

[ihbuilder]

I'm wrapping up my highway truck building and coming back to my construction equip. . after sometime on pondering this build ,I decided to change the motors ( to slow ) When I got the motors , I over looked the output speed of the motor being reduced by the differentials . since I'm taking the motor I was going to use in the TD40B I need replacements these are the right size to go side by side and got plenty of room to play with gears ratios and multi-speed trans. Also I'm going to bite the bullet and buy the hydros .

Steve

[ihbuilder]

I put this back on the bench after I saw Steve do a motor swap on his tunarocker I had 2 motor siting around with double the speed as the original , so did a motor swap and Stevie is a happy camper I was going to try to get it going for cabin fever and supprise everyone but As always not enough time to do both pan and mack we'll see how it goes though

[ihbuilder]

I got er done but It shrunk





did some push with the 25






I needed this to get some details figured out in the gooseneck area and the steering . Looks like I'll be needing to remake the gooseneck to get the steering right