|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#2
11-19-2011, 05:05 PM
|
||||
|
||||
Re: Mack M75SX
tried to hual /unload my coal again
 but not worth the vid  the dang thing is just too fast . I'm thinking 4 motors in the rear axles they're big enough . any how nuff cryin  this is the idea behind the truck and loader back my pickup to my bench and bridge to the upper section of the basement to unload my coal . some pics looking in at the hopper for the furnace(55gal oil drum ) at my bench the unloading dock  I guess I'm just venting a little  O by the way , any one wanna race this thing 
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
#3
11-20-2011, 09:24 PM
|
|||
|
|||
|
Re: Mack M75SX
Great setup for the haul road!
Although, as your resident health&safety expert, I urge you to install rails to prevent your beaut from plunging to death About the speed: Can't you squeeze in a reduction gear box? Your axles are sweet, wouldn't tear them apart. Also, while my grader runs on wheel motors, a shaft drive is more realistic for most machines. Good luck either way!
|
|
| Currently Active Users Viewing This Thread: 27 (0 members and 27 guests) | |
|
|
Hybrid Mode
