|
|
|
|
#1
03-09-2012, 06:06 PM
|
||||
|
||||
Re: Hauling Dirt out of my basement (present day)
You don't need new shafts Ed, just machine flat spots where your set screws grip. Drilling a hole for a set screw pin might weaken the shafts to twist off/break at the holes.
Here's pic showing the hole I had to cut in the 850 body b/c the vertical mount motor being too tall.  I'll get you some more pics tomorrow or Sunday for you to tilt your head & wonder Elliot.  
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
03-09-2012, 06:46 PM
|
||||
|
||||
|
Re: Hauling Dirt out of my basement (present day)
Joe , whats the thickness of the main structure plate , 3mm or 4mm ? Just curious
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
#3
03-10-2012, 01:04 PM
|
|||
|
|||
|
Re: Hauling Dirt out of my basement (present day)
Quote:
Yes please Joe, you gave us that little teaser and then you've gone on cold on me! 
__________________
Elliot.
|
|
#4
03-10-2012, 06:30 PM
|
||||
|
||||
|
Re: Hauling Dirt out of my basement (present day)
thank you Joe
you know I'm itchin  every time I run Rods at a meet  I'm getting use to running the rc 1  It was a lot easier today .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
 |
| Currently Active Users Viewing This Thread: 101 (0 members and 101 guests) | |
|
|
Hybrid Mode
