|
|
|||||||
| General Discussion A place to post off topic discussions. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-23-2013, 04:45 PM
|
||||
|
||||
Re: MORPOWER pump & valve
Current: 9amp
 that's not good.. that's going down the same road as the hk version.What's the diameter & width of the gears Ed? Maybe we can guesstimate what the flow might be?
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
|
#2
03-23-2013, 05:44 PM
|
||||
|
||||
|
Re: MORPOWER pump & valve
It could be 9A max
the description is a little vague I didn't get 1 yet but I will and try it in the TD40B as the 2 other Jungs I got are slated for the twins .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
#3
03-24-2013, 02:10 PM
|
||||
|
||||
|
Re: MORPOWER pump & valve
Quote:
9amps would be ok though if it has 4 times the power of a liembach pump. It would just be overkill for smaller hydraulic machines. Always nice to see more rc hydraulic components become available. Thanks for posting pics Ed.
__________________
Scott "No load is too Small"
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
