|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
04-19-2014, 03:51 PM
|
||||
|
||||
Re: left over build (Cat 825C maybe )
thanks Lou . I kinda got use to it towards the end of the show . It took me a bit to get use to grading with my eyes and not the seat of my pants
 I'm going to have a dozer next year 1 way or another . I asked Joe before but can't remember his answer . Will the Viper Marine 15 run all 4 motors ? or should I go with 2 (1/axle) or bump up to Viper Marine 40 ?
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
|
#2
04-19-2014, 06:34 PM
|
||||
|
||||
|
Re: left over build (Cat 825C maybe )
You'll be fine with one esc Steve. That's all I have ever run in my in Stahl loader for the last 10yrs. I use a 15 with no troubles... a 20 is little extra cost now, it didn't exist when I put that 15 in it yrs ago.
I use a 2x12 Sabertooth in my Stahl 6wd adt, with the mix off, one motor controller is for/rev & the 2nd esc runs the pump. 6 motors have never stalled that 12amp rating either.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe
|
|
#3
04-19-2014, 07:01 PM
|
||||
|
||||
|
Re: left over build (Cat 825C maybe )
Joe, have you run 11.1 lipo's on them ? thats all I've been using .
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
