CAT 14M3 Motor Grader

[Hemi1966]

Originally Posted by skeeter

How I'd print the cab would depend on the size of it. IF it was small enough I could get in on my printer in one shot, I'd try it that way first.

Thanks man !
That would be the easiest way, I'm just a bit bit worried about how the window openings will turn out.

[Hemi1966]

I made the first side wall for the engine enclosure. It's quite awkward shape as it get wider at half way and the upper front corners are bevelled, due better rear visibility.

[Hemi1966]

Both sides done

[ederson]

ola boa tarde muito impressionante todo seu trabalho eu gostaria de ver um vídeo destas soldas é possível você fazer um vídeo de como você faz estas soldas?

[Hemi1966]

Originally Posted by ederson

ola boa tarde muito impressionante todo seu trabalho eu gostaria de ver um vídeo destas soldas é possível você fazer um vídeo de como você faz estas soldas?

Here is a video of the welding process. It's not this project, but you get the idea.

https://www.youtube.com/watch?v=YoXMCrlaGT4

[Hemi1966]

I made the rear wall of the engine enclosure

[CAT315C]

hello Hemi1966

Impressive. Are you soldering aluminum? Does your device have for sale?

Where can we buy one of these?

Thank you

[Hemi1966]

Originally Posted by CAT315C

hello Hemi1966

Impressive. Are you soldering aluminum? Does your device have for sale?

Where can we buy one of these?

Thank you

Here's a link to manufacturer's page: https://www.schweisstechnik-lampert....el-making/m280