|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
08-25-2010, 11:03 AM
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
Steve, When I said "would lower the final output shaft a little." I meant lower the height of the output shaft
 not the ratio.
__________________
Scott "No load is too Small" 
|
|
#2
08-25-2010, 09:56 PM
|
||||
|
||||
|
Re: Cool tranny mod for front wheel drive (Vid added)
Quote:
 no offense IHSteve
__________________
RIP FreddyGearDrive 2-12-59/12-19-11 To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
|
#3
08-25-2010, 11:03 PM
|
||||
|
||||
|
Re: Cool tranny mod for front wheel drive (Vid added)
You are welcome Bob but, I wouldn't recommend doing this conversion unless you have the time and tools because an axial trans or an f-350 trans would be a lot easier.
It probably took me 6 or 7 hours to make this but, every time a drive it I will be rewarded that I made it myself. It should sound really cool when it is done because there 8 gears driving against each other from the motor shaft to the final output shaft and there are 2 sets of those gears in metal cases, the hpi GRU and the GRU I made. No offense taken Steve! 
__________________
Scott "No load is too Small"
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
