Wa 500 Rebuild

[JDH429]

Small, Thank you, I hope so.

Azonic, Thank you! Our building is still fairly new. About 5 years old so it is pretty clean compared to our last building which was 3x smaller and filthy as ****...Couldnt walk in the building without getting dirty.

Claus, Thank you. I wish my brain was very strong....

After comparing my new center section to the old I realized i screwed up a dimension by .260" which is the thickness of the bearing holder ...So i figured instead of remaking the whole thing i cut it in half and milled the difference to bring the bearing retainers closer together where they needed to be...I unfortunately have plenty of those moments..But i think it will work out ok. 4-3mm screws per half attach the center section to the front end. Its still plenty strong and all my holes on the front end are tapped 3mm 0.5..no nuts to screw with this time.



Front end pile