|
Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
Thread Tools | Display Modes |
#5
|
||||
|
||||
Re: Cool tranny mod for front wheel drive (Vid added)
Quote:
I used two 18 tooth pinion gears (5mm bore) http://cgi.ebay.com/Traxxas-Tra5644-...efaultDomain_0 and one 22 tooth pinion gear http://cgi.ebay.com/Traxxas-E-Maxx-2...ts_Accessories The size of the center gear will not change the ratio as long as the 2 outside gears are the same. So, you could run a 28t 32p gear for the idler gear and that would lower the final output shaft a little. 28t 32pitch 5mm bore gear: http://cgi.ebay.com/CASTLE-CREATIONS...ts_Accessories
__________________
Scott "No load is too Small" |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|