burder road roller

[lee.means]

here is my little cat roller

[lee.means]

sorry for the back pic my phone sucks

[grumpygrady]

nice conversation please show more

[lee.means]

what would like to see

[louie r/c nut]

Very nice .

[FlyingBeagle]

Would love to see more detail on how it is driven.

[justin]

Any videos of it

[Rd/Rz]

I am just finishing one of these conversions, managed to keep all the electronics in the front section . Never took the rear apart . Used 2 micro servos converted to 360 ,spektrum micro Rx ,4 cell Nimh from a receiver pak .

[Stuff]

nice!

[lee.means]

Originally Posted by Rd/Rz

I am just finishing one of these conversions, managed to keep all the electronics in the front section . Never took the rear apart . Used 2 micro servos converted to 360 ,spektrum micro Rx ,4 cell Nimh from a receiver pak .

im just about all done i am using 3 hxt 900 micro servos. 2 vibrates from a old xbox360 and iv add about 2.0 lbs to the drums and im up to 6v

[MoRockN]

Very nice. I did a roller like this also but I wanted a drum mounted motor just like the real ones. I'll see if I can find any pictures.

[Kaf343]

Very cool roller

[grumpygrady]

Originally Posted by MoRockN

Very nice. I did a roller like this also but I wanted a drum mounted motor just like the real ones. I'll see if I can find any pictures.

is there a build thread?

[MoRockN]

Originally Posted by grumpygrady

is there a build thread?

There isn't one as I did it before I joined this forum. But I found some pictures and I will post a build thread

[lee.means]

you can post them on here if u want

[5inchman]

Originally Posted by MoRockN

There isn't one as I did it before I joined this forum. But I found some pictures and I will post a build thread

Hi, I've had one of these rollers on the bench for a year trying to work out how to fit the motors in the rolls. I would appreciate any help and pictures you could provide.

Cheers
5inch

[lee.means]

its super ez take off the roller you will need to make a cut buy the eagle so a round servo horn can go throw. (oh and you will need a round servo horn with a o-ring on it) i used o-ring w/hot glue and hot glue and a zip tie to hold it in the right place

[lee.means]

sorry my camera sucks. hope it helps

[lee.means]

Originally Posted by lee.means

sorry my camera sucks. hope it helps

see if this helps

[5inchman]

Originally Posted by lee.means

see if this helps

That is great stuff lee, i'd like to see how others have fitted motors in the drums.
You even got it to vibrate?

Regards

5inch